 | Ratings: 1 to 50 HP at 230 VAC
1 to 400 HP at 460 VAC |
| Speed Regulation: 0.01% of base speed |
| Overload capacity: 150% 1 min. (200% peak) |
| Stall torque: up to 150% rated at zero rpm for 1 minute. 100% continuous. |
| Electronic reversing |
| Adjustable accel and decel: 0.1 to 3000 sec |
| Controlled speed range of 1000:1 (Zero rpm to twice base speed.) |
| Maximum speed range 12,000 RPM (400 Hz) up to 200 HP |
| Torque limiting circuit: 0-200% of rated |
| Drive efficiency: 96-98% |
| Displacement power factor : 0.98 |
| Speed resolution: 0.01% w/digital 0.1 % w/analog |
| Speed regulation 15°-35°C: 0.01% w/digital
0.1% w/analog |
| Jog forward and reverse |
| Power loss ride-thru: 2 seconds, 1 second below 5 HP |
| Encoder Freq Response of 300 KHz |
| Dual motor selection |
| Built-in Auto-tuning |
| Speed / torque mode selectable |
| Digital flux vector, sine-coded PWM |
| 32-bit microprocessor logic,including 16-bit DSP |
| Run and fault display |
| Run and fault contacts for customer use: I A at 250 VAC or 30 VDC |
| Touch pad operator controls |
| Digital speed meter, five digit |
| Protected chassis standard (panel mount NEMA 1, 4/12 optional) |
| 24 VDC control logic |
| Carrier frequency: 2.08 KHz factory set. 12.5 kHz selectable with derating |
| Open / closed loop (spec.) |
| Speed response of 100 Hz |
| 1 ms scan rate |
| Low noise capability thru 200 HP with derating |
| 9 Multi-speed settings |
| Remote speed reference: Bipolar ±0-10 VDC (20K ohms) or 4-20 mA (250 ohms) |
| Signal follower: bias and gain adj. |
| Programmed analog monitors output: ±0-10 VDC proportional to output speed and current |
| Surface mount device technology |
| Over 100 programmable functions |
| Pulse monitor |
| High resolution bipolar analog input MTBF of 28 years
|
| Input circuit breaker / disconnect |
| Remote operator's station (2-wire or 3-wire) |
| High precision analog command input |
| High accuracy torque controller |
| Digital monitor |
| High precision analog monitor output |
| Programmable dynamic braking |
| Master ratio module, voltage or current input |
| PID controller module |
| Set point controller module |
| V / I converter module |
| Serial communications |
| Support tool |
| CTCW (constant tension center winder) |
