 | Ratings: 1/4 to 5 HP at 230 VAC,
1/4 to 5 HP at 460 VAC |
| Constant torque overload rating: 150% for 1 min. (200% peak) |
| DC injection braking, ramp to stop |
| Electronic reversing |
| Adjustable accel/decel: 0.1 to 600 seconds |
| Controlled speed range: 40:1 |
| Torque limiting circuit: 30-200% of rated |
| Drive efficiency: 95% |
| Displacement power factor: 0.98 |
| Output frequency: 0.1 to 400 Hz |
| Frequency resolution: 0.1 Hz with digital reference 0.06 /60 Hz with analog reference |
| Frequency accuracy (-10 to 40 C): 0.01 % with digital command
0.1% with analog command |
| Volts / hertz ratio: infinitely adjustable pattern |
| DC injection braking: adjustable amplitude, duration, current limited |
| Torque boost: full range, auto |
| Power loss ride-thru: 1 sec |
| Speed search |
| Auto restart |
| Critical frequency rejection |
| 16-bit microprocessor logic |
| LED status display |
| Programmable form C contacts for customer use: 1A at 250 VAC or 30 VDC |
| 24 VDC control logic |
| Carrier frequency: 2.5-15 kHz |
| Multi-speed settings: 5 (2-wire), 4 (3 wire) |
| Remote speed reference: 0 -10 VDC (20K ohms) or 4 -20 mA (250 ohms) |
| Signal follower: bias and gain |
| Analog monitor output: 0-10 VDC proportional to output frequency or current |
| Over 50 programmable functions |
| NEMA 1 enclosed |
| UL listed-, CSA approved; IEEE STD 444 (ANSi-C343); IEC: 146A |
| Fully EMC compliant when optional FIR filter connected |
| MTBF: exceeds 28 years |
| Digital keypad operator |
| Remote operator's station |
| Pressure to electrical transducer |
| Dynamic braking resistor |
| Input circuit breaker / disconnect |
| Line bypass with magnetic contactors |
| Master ratio module, voltage input |
| PID controller module |
| Set point controller module |
| V / I converter module |
| 24 VDC control input card |
| 115 VAC control input card |
| Analog speed input card |
| Remote interface panel (provides RS232 port) |
| Din Rail Kit |
| Enclosures: NEMA 1, 4 and 12 |
| Serial Communications choices
|
