 |
Ratings: 1/8 to 5 HP at 230 VAC,
1/4 to 5 HP at 460 VAC |
| Constant torque overload rating:
150% for 1 min. (200% peak) |
|
DC Injection braking, ramp to stop |
|
Electronic reversing |
|
Adjustable accel/decel:
0.1 to 999 seconds |
|
Controlled speed range: 40:1 |
| Speed Regulation
+/- 0.5 to 1% with slip compensation |
|
Drive efficiency: 95% |
|
Displacement power factor: 0.98 |
|
Output frequency: 1.5 to 400 Hz |
|
Frequency resolution:
0.01 Hz with digital reference
0.06 / 60 Hz with analog reference |
|
Frequency accuracy:
0.01% with digital command
0.5% with
analog command |
|
Volts / hertz ratio: infinitely adjustable pattern |
|
DC Injection braking: adjustable amplitude,
duration, current limited |
|
Torque boost: full range, auto |
|
Power loss ride-thru: 0.5 sec. |
|
Speed search |
|
Auto restart |
|
2 Critical frequency rejection settings |
|
Slip Compensation
Design Features |
|
16-bit microprocessor logic |
|
Digital keypad operator with analog speed pot |
|
LED status display |
|
Copy Keypad Function |
|
Remote Mount Keypad Capability |
|
4 multifunction digital Inputs |
|
Programmable form C output contact for customer use: 1A at 250 VAC or 30 VDC |
|
24 VDC control logic compatible with sourcing or sinking outputs (PNP or
NPN) |
|
Carrier frequency: 10 kHz maximum |
|
8 multi-speed settings plus jog speed |
|
Remote speed reference: 0-10 VDC (20 kohms) or 4-20 mA (250 ohms) |
|
Signal follower: bias and gain |
|
Analog monitor output: 0-10 VDC proportional to output frequency or output current |
|
79 parameters |
|
Cooling fan controlled by drive run/stop |
|
UL and cUL listed; CE approved |
|
UL recognized electronic overload |
|
MTBF: exceeds 28 years
Protective Features |
|
Current limit, stall prevention during
accel, decel, and run |
|
Motor and drive overload |
|
Over voltage |
|
Instantaneous over current |
|
Short circuit |
|
Under voltage |
|
Heatsink overheat |
|
Ground fault protection |
|
Over torque
Service Conditions |
|
Ambient service temperature:
-10° to 50°C (14° to
122°F) |
|
Ambient storage temperature:
-20° to 60°C (-4° to
140°F) |
|
Humidity: to 95% non-condensing |
| Altitude: to 3280 ft; higher by derating |
|
Service factor: 1.0 |
|
Input voltage: -15% to +10%
200 to 230 VAC,
380 to 460 VAC |
|
Input frequency: +/-5%; 50/60 Hz |
|
Phase sequence insensitive
Options |
|
Dynamic Braking resistor (external) |
|
Input circuit breaker / disconnect |
|
Remote operator station |
|
Serial Communications |
|
NEMA 1, 12, or 4 enclosures |
|
External DC link reactor |
|
RS485/RS422 serial communication port
(up to 32 nodes). Baud rate of 19.2 kbps
|
