NOTES:
1. The above list prices include standard-fitted pump(s) close-coupled to
submersible motor(s). Motors have 25-ft. water-proof cables.
2. No controls are included in the above list prices.
3. List prices shown above cover pumps built with totally enclosed submersible
motors. For Underwriters Laboratory (U.L.) labeled motors rated for Class 1,
Group D Hazardous Duty (Explosion-Proof) service, see list price additions on
Page VSS-2-1/2D-2.
THERMAL SENSORS:
To add thermal sensors in the motor windings to sense thermal overload in
the motor, add per motor --- $90
Note: If these sensors are to be furnished, add for the required relay in the
SBS controller or other controller being used.
MOISTURE DETECTION:
The VSS motor can be furnished with two electrodes in the seal chamber to
detect the presence of water in the seal chamber.
Add per motor --- $285
If these electrodes are to be furnished, add for the required relay in the SBS
controller or, if an SBS controller is not being used, add a moisture detection
relay for each pump.
Type 2800 (includes outer seal failure test light and push button):
NEMA-1 --- $954
NEMA-4 --- $1332
Type 2810 (includes outer seal failure test light, pushbutton &
indic.light):
NEMA-1 --- $1062
NEMA-4 --- $1485
ALL-BRONZE PUMP ENDS:
Make the following list price addition to the standard unit list prices to
cover all-bronze pump ends (does not include motor housing which remains cast
iron).
Single --- $1560
Duplex --- $3120
STAINLESS STEEL FASTENERS:
To add for stainless steel exterior fasteners for pump end add $210 list per
pump
LONGER CABLES:
For cable lengths longer than standard, add $30 list per motor per foot of
extra cable length required. This modification will lengthen delivery time of
the motor.
EXPORT BOXING:
Add 2% of the equipment list price to the equipment list price to cover
export boxing.
EPOXY COATING:
For epoxy coating of all internal surfaces of the VSS pump, including the
impeller, add $198 list per pump.
SUBMERSIBLE FLOAT SWITCH:
Submersible float switch (NEMA-6) for mounting on pump discharge pipe for
actuating pump or alarm. Switch is complete with rod, float and
mounting bracket --- $1065
Note: Maximum control voltage is 250V. Specify desired float travel, i.e.:
2-ft., 4-ft., 8-ft.
PEDESTAL MOUNTED FLOAT SWITCHES AND ALTERNATORS:
One pedestal mounted float switch for single unit (FS-1)
--- $828
Two pedestal mounted float switches for duplex unit (FS-2) ---
$1656
One pedestal mounted alternating float switch for duplex unit
(FS-3) --- $1242
One pedestal mounted alternating float switch plus one pedestal mounted
auxiliary float switch for duplex unit (FS-4) --- $2070
OTHER MODIFICATIONS AND ACCESSORIES:
High water alarms and alarm bells see Sec.4, VSA pages
| OTHER MODIFICATIONS AND ACCESSORIES: |
| High water alarms and alarm bells |
see Sec.4, VSA pages |
| NEMA-4 water-tight float switch enclosures |
see Sec.8,Page X-4 |
| Stainless steel floats and float rods |
see Sec.4, VSA pages |
| Mounting of controls |
see Sec.4, VSA pages |
| Motor starters and disconnect switches |
see Sec.4, VSA pages |
| Motor starter modifications |
see Sec.4, VSA pages |
| Duplex control panels (single enclosure) |
see Sec.8, Pages X-5 & X-5A |
| Steel pit covers and grouting frames |
see Sec.4, VSA pages |
| Steel, cast iron & fiberglass basins |
see Sec.4, VSA pages |
| Special control enclosures |
see Sec.8 |
TYPE SBS SUBMERS-A-BULB CONTROLLERS:
Type SBS Submers-a-bulb controllers are recommended for control of VSS
submersible pumps. See Section 4, Bulletin 263 and applicable price sheets.
U.L. LABELED EXPLOSION-PROOF MOTORS:
For pumps built with Underwriter's Laboratory (U.L.) labeled motors rated
for Class l, Group D hazardous duty (explosion-proof) service, make the
following list price additions:
