MC-1 AND MMC-1

Member of:

Official website of:

Federal Pump Corp.

Motors, Pumps, Controls, Drives, Hoists

Type MC & MMC

MIDGET CONDENSATE DISPOSAL UNITS
Bulletin 111B

	Cold condensate drip from air conditioning unit coils
	Pumps to sink or drain where gravity drainage is impractical
	Pump and switch removable without disconnecting inlet piping
	Factory assembled unit
	Easy installation
	Simple maintenance
	Optional float operated high water alarm switch and automatic cut-out switch to prevent receiver overflow

FEATURES

TANK: Heavy fabricated steel - 5 gallon capacity

PUMP: Standard-fitted construction with stain-less steel shaft, bronze bearing and aluminum impeller. Pump has a capacity of 5 G.P.M at a maximum pumping head of 20 Feet.

MOTOR: 1/3 H.P., 1750 R.P.M., single phase, 60 cycle, 115 or 230 volts, with built-in overload protective device. 115 volt motor is supplied with covered extension cord and plug. 230 volt motor is supplied with conduit box for electrical connection.

FLOAT SWITCH: Built into motor and fully protected from damage. Operated by stainless steel cable and two displacement weights.

OPTIONAL HIGH WATER CUT-OUT AND ALARM SWITCH: (MMC-1 UNIT) Standard MC-1 unit can be modified by the addition of an extra integral float switch with one set of normally open and one set of normally closed contacts. This modification is called the MMC-1 unit. On the MMC-1 unit the float switch is actuated if water in the tank rises to a dangerous level. Switch will automatically shut down the air conditioning unit and simultaneously activate an audible or visual alarm, thus preventing overflow from the tank. (Note For Electrician: Connect normally closed contacts to holding coil circuit of the magnetic started for the air condition unit. Connect normally open contacts to the alarm device.)

PERFORMANCE TABLE

Capacities	Pumping Heads
25 GPM	05 FT
20 GPM	10 FT
15 GPM	15 FT
10 GPM	20 FT

TYPE MC-1 & MMC-1	SECTION 1
MIDGET CONDENSATE DISPOSAL UNITS	PAGE MC-1
BULLETIN 111	FEBRUARY 2001

LIST PRICES cover factory-assembled units for condensate disposal in air conditioning systems. The unit includes (1) receiver, (1) pump, (1) motor and (1) float switch assembly (plus (1) cut-out and/or alarm float switch on MMC-1 units).

Motors are single phase, 60 cycle, and are available for 115V. or 230V. service. The same list prices apply for either voltage. Specify voltage when ordering.

MODEL	H.P.	R.P.M.	RECEIVER CAPACITY	RECEIVER MATERIAL	LIST PRICE	SHIP'G WEIGHT
MC-1	1/3	1750	5-gallon	STEEL	$1590	50#
MC-1	1/3	1750	5-gallon	POLYETHYLENE	$1527*	40#
MMC-1	1/3	1750	5-gallon	STEEL	$2055	60#

* Fire Codes and/or Building Codes of certain jurisdictions limit the use of polyethylene in buildings, due to the formation of toxic gases upon combustion.

TYPE MC-1 & MMC-1	SECTION 1
MIDGET CONDENSATE DISPOSAL UNITS	PAGE MC-2
BULLETIN 111	FEBRUARY 2001

PARTS PRICES

NOTE: All list prices shown on this page are subject to parts multipliers.

PART NO.	DESCRIPTION	NO. REQ'D#	LIST PRICE
1	Pump casing	1	$321
2	Impeller	1*	105
33	Shaft	1*	117
38	Suction plate	1	57
40	Coupling	1*	60
46	Adjusting screw	2*	6
52	Lock washer, each	-	6
53	Support plate	1	195
56	Support leg	1	57
57	Pump bearing	1*	33
63	Discharge pipe	1	63
67	Motor set screw	3*	6
67	Support leg set screw	1	6
67	Support plate screw	3	6
67	Machine screw	5	12
70	Discharge elbow	1	33
72	Float rod & stops	1-set	66
74	Float switch	1*	120
74A	H.W. cut-out fl. sw.	1**	648
80	Float	1*	90
110	Motor	1	783
134	Power cord and plug	1	57
139	Tank (steel)	1	669
139	Tank (Polyeth.)	1	618
-	Pump only	-	1035
-	Complete unit less tank	-	1200

# LIST PRICES SHOWN ARE FOR EACH PIECE. MULTIPLY BY NO. REQ'D.

* Recommended spare parts to be carried in stock.

** For MMC-1 units only.

Prices are FOB factory, Brooklyn, New York.

TYPE MC-1 & MMC-1	SECTION 1
CONDENSATE DISPOSAL UNITS	CURVE PAGE MC-1
BULLETIN 111	JULY 1984

TYPE MC-1 & MMC-1
MIDGET CONDENSATE DISPOSAL UNITS
CROSS-SECTION & PARTS LIST
DATA NO. 111.1A

PART NO.	DESCRIPTION	NO. REQ'D#	MATERIAL
1	Pump casing	1	Cast Iron
2	Impeller	1*	Aluminum
33	Shaft	1*	St. St.
38	Suction plate	1	Cast Iron
40	Coupling	1*	Steel
46	Adjusting screw	2*	Steel
52	Lock washer	5	Steel
53	Support plate	1	Aluminum
56	Support leg	1	Steel
57	Pump bearing	1*	Bronze
63	Discharge pipe	1	Galv. Steel
67	Support plate screw	3	Cadmium Steel
67	Motor set screw	3*	Steel
67	Support leg set screw	1	Steel
67	Machine screw	5	Brass
70	Discharge elbow	1	Galv. Mall. Iron
72	Float stop	4	Aluminum
74	Float switch	1*	Various
74A	H.W. cut-out fl. sw.	1**	Various
80	Float	2*	Plastic
110	Motor	1	Various
134	Power cord and plug	1*	Various
139	Tank	1	Steel
148	Float rod	1*	Brass

*Recommended spare parts to be carried in stock.

** Not Shown. Furnished on MMC-1 units only.